Installing the actuator on the hood hinge
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Insert the actuator (3) into the rear guide pin and push it toward the rear up to the stop.
- Replace the screw (2).
Parts: screw
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Actuator to engine compartment lid hinge | ||
|---|---|---|
| M6x10 Replace screw. |
tightening torque | 8 Nm |
- Connect connectors (1) and lock.
Follow-up work
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .