Partially fastening the protective plate to the roof
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Put a drop of screw locking agent on the thread of each screw before screwing.
ADHESIVE SPECIFICATIONS
| Screw lock Loctite Stick 243, medium strength | 10 ml, Bottle | 83192210339 |
NOTE:
Perform the steps on the right and left side.
- Install holder (3).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder to roof | ||
| Screw M6x16 | tightening torque | 10 Nm |
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate of the roof to the holder | ||
| Hexagon screw M8x25 | tightening torque | 35 Nm |
| Hexagon screw M10x30 | tightening torque | 70 Nm |
- Put a drop of screw locking agent on the thread of each screw before screwing.
ADHESIVE SPECIFICATIONS
| Screw lock Loctite Stick 243, medium strength | 10 ml, Bottle | 83192210339 |
- Tighten all the screws of the protective plate (1) in the area of the dotted line.
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate of the roof to the holder | ||
| Hexagon screw M8x25 | tightening torque | 35 Nm |
| Hexagon screw M10x30 | tightening torque | 70 Nm |
NOTE:
Perform the steps on the right and left side.
- Tighten the screws (1) on the head airbag.
TIGHTENING TORQUE SPECIFICATIONS
| Head airbag to bodyshell | ||
| screw | Tightening torque | 8 Nm |