Installing left and right C-pillar trim panels at the bottom (3rd row of seats)

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Description is for left component only. Procedure on the right side is identical.

Check the clips (1) for damage and replace where required.
Check the guide pin (2) for damage, replace the C-pillar trim panel if applicable.

Courtesy of BMW OF NORTH AMERICA, INC.
Correctly position the C-pillar trim panel (2) and clip in at the clips (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the strap fitting at right rear on the body (3rd row of seats)

Prerequisite

2nd row of seats is adjusted all the way to the front.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Strap fitting on the lower body
Screw Replace screw	Tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in the rubber cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.