When replacing intake camshaft: Remount camshaft sensor wheel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate intake camshaft, if necessary in the position shown up to the recess (2).
- Loosen screw (1).
- Guide out and remove the camshaft sensor wheel (1).
- Guide the camshaft sensor wheel (1) into the new intake camshaft.
- Rotate intake camshaft, if necessary in the position shown.
NOTE:
The recess (2) must point up.
- Position camshaft sensor wheel and tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Camshaft sensor wheel to intake camshaft | |
|---|---|
| M4x35 | Tightening torque 4.5 Nm |