Installing the base plate and holder for the pennant holder
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Tighten the screws (1) for the holder for pennant holder (2) hand-tight.
- Hand-tighten the screws (3).
- Mount the expanding rivets (4).
- Position base plate for pennant holder (1).
- Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATIONS
| Base plate to base plate holder | ||
|---|---|---|
| Nut M6 | Tightening torque | 12 Nm |
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Base plate holder to carrier support | ||
|---|---|---|
| M6 screw Use the screw lock Loctite 243 . |
Tightening torque | 12 Nm |
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Base plate holder | ||
|---|---|---|
| M6 screw Use the screw lock Loctite 243 . |
Tightening torque | 12 Nm |