Install the acoustic cover for the oil sump
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in and install the acoustic cover (2) of the oil pan.
- Secure expanding rivet (1).
- Check the Christmas tree clip (1) for damage, replace if necessary.
Parts: Christmas Tree clip
- Attach the Christmas tree clip (1).
- Secure expanding rivets (1) and (2).
- Secure expanding rivet (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Position the transmission oil lines (1) on the bracket (2).
Make sure the marks (3) are positioned correctly on the holder (2).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Insert and install the holder (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder for transmission oil line | ||
| Screw | Tightening torque | 4 Nm |
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Secure clamps (2).
- Insert and install the positive battery cable (4).
- Secure positive battery cable (4) at the clamp (5).
- Tighten the nut (3) hand-tight.
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Correctly attach the positive battery cable (1) to the anti-twist lock (2).
- Tighten the nut (3).
TIGHTENING TORQUE SPECIFICATIONS
| Battery positive lead to starter | ||
| M8 | Tightening torque | 13.5 Nm |
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .