Attaching the brake caliper on the left and right
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Fastening the brake caliper
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Detach and remove the special tool 2 413 317
.NOTE: Do not allow the brake caliper (1) to hang from the brake hose.
- Position the brake caliper (2) on the swivel bearing.
- Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Brake caliper/brake anchor plate at front swivel bearing M12
Replace screw.tightening torque 110 Nm - Attach the cable (2) on the holder (3).
- Only left:
Attach the cable (1) on the holder (3).
- Fasten brake hose (1) to the brackets (2).