If installed: Fasten the auxiliary heater
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stationary heating system.
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Holder to body M8 Tightening torque 19 Nm - Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATIONS
| Stationary heating system to holder | ||
| M8 | Tightening torque | 19 Nm |
Installing the front section of the front wheel arch cover
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Guide in the front section (1) of the wheel arch cover.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Wheel arch cover | ||
| Thermoplastic hexagon screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |