Installing the protective plate on the brake fluid expansion tank
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Install the protective plate (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate to holder | ||
|---|---|---|
| Nut M8 | tightening torque | 10 Nm |
| Flat-head screw M8x22 | tightening torque | 35 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .