Installing the belt pulley on the torsional vibration damper
- Position the belt pulley (2) .
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Belt pulley on torsional vibration damper | ||
|---|---|---|
| M10 screw | Tightening torque | 40 Nm |
Follow-up work
- Refer to INSTALLING DRIVE BELT
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT
- Refer to INSTALLING INTAKE FILTER HOUSING
- Refer to INSTALLING THE RIGHT STRUT BRACE
- Refer to INSTALLING THE STRUT BRACE
- Refer to INSTALLING ACOUSTIC COVER
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER
- Refer to INSTALLING UPPER CROSS CONNECTION
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT