Install drive belt
NOTE:
For a better overview the removed condition is shown here.
- Thread in and install the drive belt (1).
- Maintain the preload of the belt tensioner (1) using a suitable socket wrench (3).
- Remove the special tool 0 496 268 (11 0 390)
(2) from the belt tensioner.
- Loosen the belt tensioner (2) counterclockwise using a suitable socket wrench (1).
Follow-up work
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT AND LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING BOTH INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .