Installing coolant pumps

• Loosen screw (1).
• Feed out coolant line (2) and remove.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the coolant pump (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Coolant pump to component carrier
  M6x20	tightening torque	10.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Coolant pump to component carrier
  M6x20	tightening torque	10.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Coat the sealing ring (1) on the coolant line (2) with fresh coolant.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the coolant line (2) and install it.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Coolant line of coolant radiator to coolant pump
  M6x20	tightening torque	10.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock coolant line (1).

  The coolant line (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed the cleaning cloth (1) out of the crankcase (2) and set it aside.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COOLANT LINE BETWEEN THE CYLINDER HEAD AND THE COOLANT PUMP .
• Refer to REPLACING FRONT CRANKSHAFT SEAL .
• Refer to INSTALLING THE VIBRATION DAMPER .
• Refer to INSTALLING STARTER MOTOR .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL SUMP .
• Refer to INSTALLING THE DRIVE BELT FOR THE STARTER MOTOR GENERATOR .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING THE CLEAN AIR PIPE AND THE RESONATOR .
• Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .