Install the center console

• Position center console (1).
• Connect the connector (2) to the Head Unit High (HU-H) and lock.
• Correctly position the center console (1) and install.

  While doing so, feed the remaining cables into the center console.

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the right and left side.
• Tighten the nuts (1) and bolts (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Center console to body
  M6x16 screw
  	Tightening torque	4.6 Nm
  Nut M6
  	Tightening torque	4.6 Nm

  Courtesy of VOLVO CARS CORPORATION

• Connect connectors (1) and lock.

  Courtesy of VOLVO CARS CORPORATION

• Connect the connector (1) to the right side of the center console and lock.

  Courtesy of VOLVO CARS CORPORATION

• Connect connectors (1) and lock.
• Hook the connector (1) into the holder.

  Courtesy of VOLVO CARS CORPORATION

• Guide in the mount for the cup holder (2) and position it correctly.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Mount for rear drink holder cover on body
  M6x16 screw
  	tightening torque	4.6 Nm

  Courtesy of VOLVO CARS CORPORATION

• Carry out only for G07: 
• Attach the cup holder (2) and connect the connectors.
• Correctly position the cup holder (2) and engage it in the front clamps.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear drink holder on holder
  Oval-head screw
  	tightening torque	2.0 Nm

  Courtesy of VOLVO CARS CORPORATION

• Install the inserts in the cup holder (2).

Follow-up work 

• Refer to PARTIALLY INSTALLING STORAGE COMPARTMENT OF CENTER ARMREST .
• Refer to INSTALLING THE CARPET ON THE CENTER CONSOLE AT LEFT AND RIGHT SIDES .
• Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .