Installing rear brake hose

• Attach brake hose to the holder (1).
• Fit and tighten brake hose (2) on brake caliper.

  Never twist brake hose and avoid all contact with components attached rigidly to the body.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake hose to brake caliper, rear
  	tightening torque	24 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach and tighten union screw (1).

  Hold on to square shaft, if necessary (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH THE REAR BRAKE AND AIR BLEEDING (AFTER PART EXCHANGE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .