Removing cowl lower part

NOTE: TECHNICAL INFORMATION
Before installing the cowl cover, it is imperative to check the correct routing and firm fit of the 48V line.
An incorrectly laid or attached 48V line can be damaged by the wiper kinematics.

Preliminary work

Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
Refer to REMOVING LEFT AND RIGHT WIPER ARM .
Refer to REMOVING THE COWL COVER .
Refer to REMOVING REAR HOOD SEAL .
Refer to REMOVING THE CENTER COWL UPPER PART .
Refer to REMOVING THE STRUT BRACE AT THE LEFT AND RIGHT .

Loosen nuts (1) .
Loosen screws (2) .
Feed out and remove the lower part of the cowl (3) .

Courtesy of BMW OF NORTH AMERICA, INC.