Install exhaust cover

• Insert the exhaust cover (2) on the holder and engage at detent (3).
• Replace screws (1).

  Parts:  Screw

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Exhaust cover on holder
  Screw Replace screw
  	tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

• Install the bracket (2) together with the exhaust cover.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Exhaust cover holder to bumper panel
  Screw
  	tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

• Mount blind rivet (2) using the special tool  0 496 521 (00 2 230)  .
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Exhaust cover holder to bumper panel
  Screw
  	tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING REAR BUMPER PANEL  .
• Refer to INSTALLING REAR REFLECTOR .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .