Installing the roof rails
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check the seal (1) of the roof rail (2) for damage.
The seal (1) of the roof rails (2) must not be damaged or missing.
- If seal (1) is damaged, replace roof rails (2).
- Feed in and correctly position roof rail (1).
- Replace nuts (1) and (2).
Parts: Nuts
- Tighten nuts (1) and (2) in the following order: Center - rear - front TIGHTENING TORQUE SPECIFICATIONS
Roof railing to body Nut, self-locking Replace nuts Tightening sequence: Center, rear, front
Tightening torque20 Nm
Follow-up work
- Refer to INSTALLING THE HEADLINING (LOWERED) .
- Refer to INSTALLING REAR INTERIOR ROOF LIGHT .
- Refer to INSTALLING ALL GRAB HANDLES .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING COUNTER SUPPORTS FOR THE LEFT AND RIGHT SUN VISOR .
- Refer to INSTALLING THE LEFT AND RIGHT SUN VISOR .
- Refer to INSTALLING LEFT AND RIGHT A-PILLAR TRIM PANEL .
- Refer to PARTIALLY INSTALLING THE B-PILLAR TRIM PANELS AT THE TOP LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING D-PILLAR TRIM PANEL ON LEFT AND RIGHT .