Remounting the LED module for the right daytime running lights

Replacing the LED module for the daytime running lights 

• Loosen screws (1).
• Pull LED module (2) out of headlight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock connector (1) at LED module (2) and disconnect it.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Installing the LED module for the right daytime running lights 

  NOTE: Description is for left component only. Procedure on the right side is identical.
• Check the seal (3) on the LED module (2) for damage and replace as needed.
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LED module (2) in the headlight.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  LED module of daytime running lights
  Screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.