Remove headlight

NOTE: TECHNICAL INFORMATION
In order to guarantee the quality of the Driver Assistance functions in vehicles with concealed radar sensors, the component may be repainted only in compliance with the repair specifications described in the information "Standards for refinishing paint with a sensor system".
No stickers or films (transparent or colored) may be affixed in the transmission areas of the radar sensors.
If there are no radar sensors fitted, the component may be painted.
The following features can be used to identify whether radar sensors are installed on the vehicle:
Radar sensors are installed at the rear if the triangular warning light is present on the exterior mirror (in the mirror glass or on the mirror frame).
Radar sensors are installed at the front and rear if the triangular warning light is present on the exterior mirror (in the mirror glass or on the mirror frame) in conjunction with optional equipment S5ATA or S5AUA.

Preliminary work

Refer to REMOVING FRONT ORNAMENTAL GRILLE .
Refer to PARTIALLY REMOVING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM .
Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
Refer to REMOVING FRONT BUMPER COVER .

Protect the body in area (1) with adhesive tape.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (1) and disconnect.
Loosen screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the seal (1).
Loosen the expanding rivet (2).
Lever out the trim panel (3) and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).
Feed out and remove the headlights (2) toward the front.

Courtesy of BMW OF NORTH AMERICA, INC.