Installing the tension strut at the right rear and if necessary, on the left side
Installing the right rear tension strut
Installing the rear tension strut
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut (3) .
- Tighten the screws (1)
and the nut (2)
.TIGHTENING TORQUES SPECIFICATION
Torsion strut on body and holder M12x25 Replace screws. Joining torque 100 Nm Angle of rotation 90° Nut M10 Tightening torque 38 Nm Installing the undershield (tank cover) at right
NOTE: Description is for left component only. Procedure on the right side is identical.Installing undershield (tank cover)
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Insert the undershield (l) .
- Tighten all bolts and nuts (arrows).TIGHTENING TORQUES SPECIFICATION
Undershield, side Hexagon screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm For double-flow exhaust system: Installing the rear left tension strut
Installing the rear tension strut
NOTE: TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.NOTE: Description is for left component only. Procedure on the right side is identical. - Install the tension strut (3) .
- Tighten the screws (1)
and the nut (2)
.TIGHTENING TORQUES SPECIFICATION
Torsion strut on body and holder M12x25 Replace screws. Joining torque 100 Nm Angle of rotation 90° Nut M10 Tightening torque 38 Nm Installing undershield (tank cover)
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Insert the undershield (l) .
- Tighten all bolts and nuts (arrows).TIGHTENING TORQUES SPECIFICATION
Undershield, side Hexagon screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm