Install bracket for right intake silencer
- Position holder (3).
- Tighten the screws (1).
Tightening Torques
| Screw on the holder of the intake silencer | ||
| M6x16 screw | Tightening torque | 8 Nm |
- Tighten nut (2).
Tightening Torques
| Nut on the holder of intake silencer | ||
| Nut M6 | tightening torque | 8 Nm |
- Version with a gasoline particulate filter:
Position holder (2) of the gasoline particle sensor.
Tighten the screws (1).
Tightening Torques
| Screw on the holder of the intake silencer | ||
| M6x16 screw | tightening torque | 8 Nm |