Install D-pillar trim panel on left and right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing D-pillar trim panel
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: 72 00... SAFETY REGULATIONS ON HANDLING AIRBAG SYSTEM COMPONENTS/GAS GENERATORS
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: 72 00... SAFETY REGULATIONS ON HANDLING AIRBAG SYSTEM COMPONENTS/GAS GENERATORS .
- Check the clips (1) for damage and replace where required.
- Correctly position D-pillar trim panel (3) and clip in at the clips (2).
- Make sure that the D-pillar trim panel (3) is correctly positioned on all adjacent parts.
- Tighten the screw and mount the cover (1).TIGHTENING TORQUES SPECIFICATION
D-pillar trim panel on body M6x35 screw tightening torque 3.0 Nm