Attach the wiring harness of the active stabilizer (additional work, flat rate unit number: 37 11 999)
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Secure cable with the holders (3) on the side member.
- Connect connectors (2) and lock.
- Replace the bolts (arrows).
Parts: Screw
- Tighten screws (arrows).TIGHTENING TORQUES SPECIFICATION
Connector bracket for active stabilizer to side member M6 Replace screw. Tightening torque 4 Nm - Connect connectors (1) and lock.