Install right heat shield
- Thread in right heat shield (2) and connect with the other heat shield.
- Tighten the screw (1)
at the top of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1)
at the bottom of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Tighten down screw (1)
.
- Position the holder of the pressure lines.
Tighten screws in areas (1) .
TIGHTENING TORQUE SPECIFICATIONSPressure line lug to the lateral side of the heat shield M6x16 screw Tightening torque 8 Nm
- Thread in right heat shield (2) and connect with the other heat shield.
- Tighten the screw (1)
at the top of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1)
at the bottom of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm