Install left heat shield
- Feed in left heat shield (2) and connect to the other heat shields.
- Tighten the screw (1)
at the top of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1)
at the bottom of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Tighten down screw (1)
.
- Position the holder of the pressure lines.
Tighten screws in areas (1) .
TIGHTENING TORQUE SPECIFICATIONSPressure line lug to the lateral side of the heat shield M6x16 screw Tightening torque 8 Nm
- Feed in left heat shield (2) and connect to the other heat shields.
- Tighten the screw (1)
at the top of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1)
at the bottom of heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Tighten down screw (1)
.
- Version with S1DFA:
Position the holder of the pressure lines.
Tighten screws in areas (1) .