Installing the instrument cluster (KOMBI)
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect and lock the connector (1) on the instrument cluster (KOMBI) (2).
- Guide in the instrument cluster (KOMBI) (2) in the arrow direction.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Instrument cluster (KOMBI) to support | ||
|---|---|---|
| Screw | tightening torque | 1.8 Nm |
- Position and lock the steering column shroud upper section (1).
The snap-in lugs (2) must snap in audibly.
Follow-up work
- Refer to INSTALLING THE DECORATIVE STRIP ON THE RIGHT DASHBOARD .
- Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DASHBOARD ON THE LEFT .
- Refer to INSTALLING THE SIDE PANEL ON LEFT DASHBOARD .
- Refer to INSTALLING THE INSTRUMENT CLUSTER TRIM .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .