Installing the upper B-pillar trim panel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Attach the B-pillar trim panel (1) and guide in the safety belt.
- Guide in the B-pillar trim panel (1) at the top at the roofliner and clip into the clips (2).
- Check the front and rear of the B-pillar trim panel (1) for the correct fit at the edge protection.
- Adjust the front seat completely to the front and top.
- Insert the end fitting (2).
- Replace the screw (1).
Parts: screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Seat belt strap fitting to seat mechanism | ||
|---|---|---|
| M10 Replace screw. |
tightening torque | 42 Nm |