Installing rear door trim panel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
- Check the clips (1) for damage.
- Replace damaged or missing clips (1).
The clips (1) must not be engaged. The disengaged state is shown.
- Install the door trim panel.
- Attach the Bowden cable of the door opener (1) on the door lock (3).
- Attach the Bowden cable of the door opener (1) on the counter support (2).
- Connect connectors (4) and lock.
- Insert the door trim panel (1) on the window channel strip.
- Clip in the door trim panel (1) onto the clips (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Door trim panel | ||
|---|---|---|
| screw | Tightening torque | 5 Nm |
- Tighten screw and mount cover (1).
TIGHTENING TORQUE SPECIFICATIONS
| Door trim panel | ||
|---|---|---|
| screw | Tightening torque | 5 Nm |
- Tighten screw and mount cover (1).
TIGHTENING TORQUE SPECIFICATIONS
| Door trim panel | ||
|---|---|---|
| screw | Tightening torque | 5 Nm |
Tightening the screws in the rear recessed grip (G05/G07)
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Door trim panel | ||
|---|---|---|
| screw | Tightening torque | 5 Nm |
- Install cover (1).