Installing the module bracket on the front door

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Check the peripheral seal (1) of the module bracket (2) for damage.
If the seal (1) is damaged, the module carrier (2) must be replaced.
Open all the snap fasteners (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the module bracket (2) and close the snap fasteners (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Module bracket to door
screw	Tightening torque	8 Nm

Secure the wiring harness to all cable clips.
Connect and lock all connectors to the module bracket (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnecting all battery ground leads

Courtesy of BMW OF NORTH AMERICA, INC.

Shift the power window upwards until the side window glass correctly engages in both holders.
Remove adhesive tape.

Follow-up work

Refer to INSTALLING FRONT DOOR TRIM PANEL .
Refer to MOUNTING MIRROR TRIANGLE COVER .
Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .