Replacing upper oil sump section
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen screw (1) .
- Feed out and remove the hydraulic valve (2)
for the oil pressure control.
- Loosen screws (1) .
- Guide out the bearing bracket (2)
and remove it.
- If necessary, renew the sealing ring (2)
on the hydraulic valve (1)
for the oil pressure control.
Parts: Sealing ring
- Check strainer for contamination and clean if necessary.
- Coat the sealing ring (2)
with engine oil.
- Coat the sealing ring (1)
with front axle differential oil.
- Renew the upper oil sump section.
Parts: Upper oil sump section
- Guide in and install the bearing bracket (2) .
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Bearing bracket to engine oil pan. | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Insert and install the hydraulic valve (2) for the oil pressure control.
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Hydraulic valve to oil sump | ||
|---|---|---|
| M6x18/M6x20 | tightening torque | 10 Nm |