Installing the engine on the assembly jig
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Get the set of special tools 0 495 187 (00 2 300)
ready.
Number Description 1 Assembly jig 2 Flange 3 Crank 4 cover panel 5 shelf 6 Rear shaped part 7 Collecting vessel 8 Front shaped part 9 Front wheel 10 Rear wheel with stop 11 Rubber mat - Position the mount 0 496 370 (11 8 930) (3) on the assembly jig (2).
- Fasten the mount 0 496 370 (11 8 930) (3) with screws (1).
- Tighten down screws (1).
- Position the engine (2) with a workshop crane (1) and special tool 0 490 567 (11 0 020)
on the engine support bracket.
- Position the mount 0 496 370 (11 8 930) on the engine (2).
- Secure the mount 0 496 370 (118 930)
with screws (1).
M10x35 8.8 screws must be used .
- Tighten down screws (1).
- Fasten the mount 0 496 370 (11 8 930)
(3) with screws (2).
The use of M8x35 8.8 screws is required .
- Tighten down screws (2).
- The engine (2) must be secured to the engine support bracket.
- Detach the special tool 0 490 567 (110 020) on the engine mounting brackets (3).
- Remove the workshop crane (1) with the special tool from the working area.