Installing the door sill cover strip on the rear left and right
Install the rear door sill cover strip
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
- Version A with basic seat:
Remove clips remaining in the body (1) and mount them on the door sill cover strip (3).
Check whether the clips (1) and guide (2) are present and have damage; replace if necessary.
- Version A with basic seat:
Position the rear door sill cover strip (2) on the body.
Engage rear door sill cover strip (2) on the clips (3).
Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONSDoor sill cover strip to body Screw 4.8x16 Tightening torque 1.4 Nm - Version B with electric seat:
Check whether the snap-in lugs (1) are present and have damage.
Damaged or missing snap-in lugs (1) must be replaced.
- Version B with electric seat:
Position the rear door sill cover strip (2) on the body.
Engage the rear door sill cover strip (2) on the detents (3).
Tighten down screws (1).
| Door sill cover strip to body | ||
| Screw 4.8x16 | Tightening torque | 1.4 Nm |
Installing the illuminated sill trim on the rear door sill
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
- Version A:
Check the detents (2) for damage, if necessary replace the illuminated sill trim (1).
Mount the illuminated sill trim (1) and connect and lock the connector while doing so.
Position the illuminated sill trim (1) and lock on the detentes (2).
- Version B:
Check the detents (2) for damage, if necessary replace the illuminated sill trim (1).
Mount the illuminated sill trim (1) and connect and lock the connector while doing so.
Position the illuminated sill trim (1) and lock on the detentes (2).