Securing the wiring harness section of the cylinder head cover on the right
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect connectors (3) and lock.
The connector (3) must engage audibly.
- Tighten the nut (2).TIGHTENING TORQUE SPECIFICATIONS
Positive battery cable to alternator M8 tightening torque
19 Nm - Mount cover (1) on nut (2).
- Position oil filler neck (2).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Oil filler neck M6x16 tightening torque
10 Nm - Fix clip (2).
- Tighten down screw (4).TIGHTENING TORQUE SPECIFICATIONS
Hexagon screw M6 with threaded bolt M5 Screw M6 with threaded bolt M5 tightening torque
10 Nm - Position the grounding point (5).
- Tighten nut (3).TIGHTENING TORQUE SPECIFICATIONS
Ground cable on cylinder head cover/ground pin Nut M5 tightening torque
4.6 Nm - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Wiring harness to cylinder head cover M6x16 screw tightening torque
10 Nm - Position the wiring harness (3).
- Fix wiring harness mountings (2).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Wiring harness to cylinder head cover M6x16 screw tightening torque
10 Nm - Secure the wiring harness mounting (1).
- Fix wiring harness mountings (2).
- Secure the wiring harness mounting (5).
- Secure the wiring harness of the integrated power supply module (4) to fixtures (3).
- Tighten the screws (2).TIGHTENING TORQUE SPECIFICATIONS
Wiring harness to cylinder head cover M6x16 screw tightening torque
10 Nm - Clip in transmission wiring harness (1).
- Connect and lock the connector on pressure sensor (1).
- Connect and lock connector (2) on the intake camshaft sensor of cylinder bank 1.
- Connect and lock connector (1) on the exhaust camshaft sensor of cylinder bank 1.
- Connect and lock connector (1) to (3).