Secure the wishbone on the top left and right on the swivel bearing
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Fastening the wishbone to the top of the swivel bearing
- Position journal of upper wishbone (3) in bore of swivel bearing (4).
- Replace screw (2) and the nut (1).
Parts: Bolt and nut
- Insert screw (2).
- Tighten the nut (1).TIGHTENING TORQUE SPECIFICATIONS
Upper wishbone to swivel bearing M10
Replace screw and nut.Tightening torque 56 Nm - Remove the special tool for attaching the swivel bearing.