Attach the wiring harness of the active stabilizer

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Secure cable with the holders (3) on the side member.
Connect connectors (2) and lock.
Replace the bolts (arrows).
Parts: Screw

Tighten the screws (arrows).

TIGHTENING TORQUE SPECIFICATIONS

Connector bracket for active stabilizer to side member
M6 Replace screw.	Tightening torque	4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.