Installing the protective plate on the transmission
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Equip the screws (2) with a sealing washer (3) and a washer (4) as shown in the smaller image.
The sealing washer (3) must be between the protective plate and the washer (4).
- Check whether a washer and a sealing washer are present on the screw points of the body.
If necessary, replace the damaged sealing washers and fix using adhesive.
- Feed in the protective plate (1) and position it correctly.
- Tighten the screws (arrows) and the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate to the underbody | ||
|---|---|---|
| Flat-head screw M10x30 | tightening torque | 32 Nm |
| Hexagon screw M6 | tightening torque | 4 Nm |