For replacement: Install the holder for the LED module of the light carpet

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LED module for the light carpet

Unscrew the adjustment screw (1) from the LED module (3) by turning it counter-clockwise.
Loosen the detent (2).
Guide the LED module (3) out of the guide (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the LED module for the light carpet

Position the LED module (3) in the guide (4).
Press LED module (3) into detent (2).
Turn the adjustment screw (1) clockwise to screw it into the LED module (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Clean the area (1) on the door sill trim panel (2).

CONSUMABLE SPECIFICATIONS

Cleaning agent R2

500 ml

83190417324

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the liner from the holder (1).
Insert the holder (1) into the door sill trim panel (2) and press evenly across the entire adhesive area.