Installing the cylinder head cover on the right

• Close the openings (1)  on the cylinder head.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: RISK OF DAMAGE 
  Damage to the surface  .
  The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage  .

  • Do not use any metal-cutting tools.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean the cylinder head in the area of the sealing surfaces (1)  .
• Open the openings (1)  on the cylinder head.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure that the fitting sleeves (1)  are installed.

The fitting sleeves must not be damaged or deformed.

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the circular seal (1)  .

  Parts:  Seal

• Replace seals (2)  .

  Parts:  Seals

• Replace seals (3)  .

  Parts:  Seals

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening the screws of the right cylinder head cover 

Screwing sequence of the right cylinder head cover 

Fig 1: Cylinder Head Cover Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and position the cylinder head covers.
• Apply screws (9)  and (14)  .

  It is necessary to apply screws (9) and (14) for the exact positioning of the camshaft position sensors  .

• Tighten screws in the order (1)  to (16)  .

Fig 2: Cylinder Head Cover Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the heat shield (1)  .
• Replace screws.

  Parts:  Screws

• Tighten down screws (2)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Heat protection plate
  M6x12 screw Replace screw.	tightening torque	10 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1)  .
• Remove the holder for the left charge air cooler.

Courtesy of BMW OF NORTH AMERICA, INC.