Remove drive belt
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
NOTE:
TECHNICAL INFORMATION
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
Preliminary work
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT
- Refer to REMOVING UPPER CROSS CONNECTION
- Refer to REMOVING THE TENSION STRUT AT THE SHOCK TOWER ON THE LEFT AND RIGHT
- Refer to REMOVING THE REAR TOP CROSS CONNECTION
- Refer to REMOVING THE ACOUSTIC COVER
- Refer to REMOVING SUSPENSION STRUT BRACE
- Refer to REMOVING RIGHT SUSPENSION STRUT BRACE
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING THE LEFT UNFILTERED-AIR DUCT
- Refer to REMOVING FAN COWL
- Refer to PARTIALLY DETACHING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT
CAUTION:
Spring preload
.
Injury hazard!
Injury hazard!
- The use of the specified special tool (tool) is mandatory.
- Carry out the described steps properly.
- Release the belt tensioner (2) with a suitable socket wrench (1) clockwise in arrow direction.
- Maintain the preload of the belt tensioner (1) using a suitable socket wrench (3).
- Secure the belt tensioner (1) against turning with the special tool 0 496 268 (11 0 390) (2).
NOTE:
For a better overview the removed condition is shown here.
- Feed out and remove the drive belt (1).