Installing the guide for the rear bumper cover (corner area)

• Correctly position the guide for the rear bumper panel at the side (2) and connect the plug connectors.
• Correctly position the guide for the rear bumper panel at the side (2).
• Tighten nuts (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper guide, rear
  Nut
  	Tightening torque	6 Nm

  Courtesy of VOLVO CARS CORPORATION

• Guide in and correctly position cover (3).

  Mount the expanding rivets (1).

  Tighten the nut (2).

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Lateral support on body
  Nut M6
  	tightening torque	4.6 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING REAR BUMPER PANEL  .
• Refer to INSTALLING REAR REFLECTOR .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .