Install rear bumper panel

• Install the bumper cover (3).

  Guide in bumper cover (3) and thereby connect and lock all plugs.

• Insert bumper cover (3) in the guides (2) and engage on the snap-in lugs (1).

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the right and left side.
• Lock in bumper cover in the area of the side panel on the detents.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper panel, rear
  Hexagon screw
  	Tightening torque	3.0 Nm

  Courtesy of VOLVO CARS CORPORATION

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper panel, rear
  Hexagon screw
  	Tightening torque	3.0 Nm

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the right and left side.
• Check the clip (2), it must not damaged or missing.

  Clip  , (2) always install with the sealing ring  .

• Check detents (3), they must not be damaged or missing.
• Clip in the wheel arch trim (1) with the clip (2).
• Engage the wheel arch trim (1) into the detents (3) in the area of the bumper cover.

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the right and left side.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper panel, rear
  Hexagon screw
  	Tightening torque	3.0 Nm

  Courtesy of VOLVO CARS CORPORATION

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper panel, rear
  Hexagon screw
  	Tightening torque	3.0 Nm

  Courtesy of VOLVO CARS CORPORATION

• Loosen screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper panel, rear
  Hexagon screw
  	Tightening torque	3.0 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING REAR REFLECTOR .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .