Install bumper cover, front

• Install the bumper cover (2) and engage in the detents in the area of the dashed line.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Upper bumper cover on air flap control
  screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the left and right side.
• Clip the bumper cover (2) upwards into the detents.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front bumper cover on side wall
  Hexagon screw
  	Tightening torque	3 Nm

• Connect and lock the plug (1) into the left wheel well.

  Courtesy of VOLVO CARS CORPORATION

  Courtesy of VOLVO CARS CORPORATION

• Connect and lock the plug (1) into the right wheel well.

  Courtesy of VOLVO CARS CORPORATION

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Undershield/frame
  Hexagon screw
  	tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .