Installing the oil-level sensor
- Replace seal (2) from oil-level sensor (1).
Parts: Seal
- Insert and install the oil-level sensor (3).
- Tighten nuts (2).
TIGHTENING TORQUES SPECIFICATION
| Oil level sensor to oil sump | ||
|---|---|---|
| M6 hexagon nut | Joining torque | 2 Nm |
| Tightening torque | 8.5 Nm | |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to FILLING ENGINE OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .