Installing the oil-level sensor
Prepare the oil-level sensor
- Replace sealing ring (1).
Parts: Sealing ring
- Insert and install the oil-level sensor (2).
- Tighten the nuts (arrows).
TIGHTENING TORQUES SPECIFICATION
| Oil level sensor to oil sump | ||
|---|---|---|
| M6 hexagon nut | Joining torque | 2 Nm |
| Tightening torque | 8.5 Nm | |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
- Feed in the cover (1) in the marked area and install.
Follow-up work
- Refer to FILLING ENGINE OIL .
- Refer to OPENING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to INSTALLING THE STIFFENING PLATE .