Replacing the engagement solenoid switch (all X7 models, 2019-2022)

Preliminary work needed:

Slacken nut (1).

Remove cable head (2).

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not twist cable head (2) when tightening, risk of short circuit to starter motor housing.
Line to starter Tightening torque

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the solenoid switch (1) and the spring (2).

Detach the bolt (3).

Installation note:

Check the bolt (3) for wear and grease the bolt.

Courtesy of BMW OF NORTH AMERICA, INC.