Remove front left wheel
Precondition
- Toe adjustment is within the tolerance.
NOTE:
TECHNICAL INFORMATION
Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment.
Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment.
NOTE:
TECHNICAL INFORMATION
Camber and toe-in influence each other. Adjust the toe-in first in order to simplify the adjustment procedure. The camber is exclusively adjusted by exchanging the upper wishbone. There are various wishbones for this purpose (+/-30').
Camber and toe-in influence each other. Adjust the toe-in first in order to simplify the adjustment procedure. The camber is exclusively adjusted by exchanging the upper wishbone. There are various wishbones for this purpose (+/-30').
NOTE:
TECHNICAL INFORMATION
The camber correction wishbones are used to correct the camber values by 30 minutes. To be used only if the tolerance values are exceeded or undershot.
The camber correction wishbones are used to correct the camber values by 30 minutes. To be used only if the tolerance values are exceeded or undershot.
Preliminary work
- Refer to CHECKING THE CAMBER .
Removing the wheel
NOTE:
TECHNICAL INFORMATION
A wheel lifter is recommended for easier wheel removal and installation without exertion (see applicable Dealer Equipment Catalog).
A wheel lifter is recommended for easier wheel removal and installation without exertion (see applicable Dealer Equipment Catalog).
- If several wheels are removed simultaneously: Use a piece of chalk to mark on each tire the axle and side on which the corresponding wheel is fitted.
- Release the lug bolts (arrows) crosswise and remove the wheel.
Use the matching adapter from tool set 0 492 518 (36 1 300) (wheel bolt adapter set) to release and tighten down the lug bolt with security code.