Installing the upper B-pillar trim panel

NOTE: Description is for left component only. Procedure on the right side is identical.

Attach the B-pillar trim panel (1) and guide in the safety belt.
Feed in the B-pillar trim panel (1) at the top on the headliner and clip into the clips (2).
Check the front and rear of the B-pillar trim panel (1) for the correct fit at the edge protection.

Courtesy of BMW OF NORTH AMERICA, INC.
Adjust the front seat completely to the front and top.
Insert the end fitting (2).
Replace the screw (1).
Parts: Screw

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Seat belt strap fitting to seat mechanism
M10 Replace screw.	tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.