Installing inner rear door opener

• Saw off the welding pins (1) on the inner door opener along the molding (2).

  Do not cut off the welding pin (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove welding remnants on door trim panel with a scalpel.
• Install the inner door opener (1) and lock on the snap-in lugs (2).
  NOTE: The welding pins must not protrude through the door trim panel.
• Screw in and tighten the repair screws (arrows).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Inner door opener to door trim panel
  screw	Tightening torque	2.3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  CONSUMABLE SPECIFICATION
  
  

  Repair screw  Delta PT4

  ø4 mm. 1 = 12 mm,

  07149200941

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the welding pin (3) with the locking washer (4).
  CONSUMABLE SPECIFICATION
  
  

  Lock washer

  16 mm, Outer diameter 6 mm, Shaft diameter

  52207115704

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FIBER-OPTIC CONDUCTOR FOR THE DOOR OPENER .
• Refer to INSTALLING REAR DOOR TRIM PANEL .