Installing the rear brake disc
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
NOTE:
TECHNICAL INFORMATION
Do not mix up the left and right!
Do not mix up the left and right!
- If an arrow (1) is stamped on the brake disk, it must point in the driving direction.
- Thoroughly clean the contact surface of the wheel hub and remove traces of corrosion if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disk (2).
- Position and tighten the screw (1).
- Replace screw.
Parts: Screw
- Mount brake anchor plate.
- Insert screws (1) and tighten.
- Replace screws.
Parts: Screws
TIGHTENING TORQUE SPECIFICATIONS
| Brake caliper to wheel carrier, rear | ||
| M12 Replace screw. |
tightening torque | 130 Nm |
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .