Installing the rear tension strut
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut (3).
- Tighten the screws (1) and the nut (2).TIGHTENING TORQUES SPECIFICATION
Torsion strut on body and holder M12x25 Replace screws. Joining torque 100 Nm Nut M10 Angle of rotation 90° Tightening torque 38 Nm
Follow-up work
- Refer to INSTALLING UNDERSHIELD (TANK COVER) .